Anticorrosive centrifugal fanIn the whole process of high-speed operation, dealing with the hazards of surrounding environmental elements and the equipment itself will cause the appearance of abrasion. It is because the solid particles in the anti-corrosion centrifugal fan will cause abrasive particles at a certain speed relative to the surface of the parts. Wear. More serious will harm the application of anti-corrosion centrifugal fans, the following anti-corrosion fan manufacturers will introduce the wear principle in detail.
The wear condition of anticorrosive centrifugal fans includes many complicated elements, which are usually the result of the combined effects of multiple principles. The dust particles enter the centrifugal impeller and interact with the wall. In the inlet area of the suction filter channel and all radial channels, most of the dust particles are brought in by the cyclone and the integrated effect of its own inertial force. The zero angle of attack hits the wall, and then rebounds into the flow channel. The wall material wear caused by that is a typical erosion wear. In the entrance and exit area of the suction filter flow channel, the dust particles have exercised for a long distance in the flow channel. The wall surface has a certain working pressure effect, and the wear of the raw materials on the negative side caused by that is attributed to the abrasion of dust particles. The concentration of dust particles in the surrounding area of the working pressure surface increases the damage level of dust particles.
In general, when dealing with the wear of anticorrosive centrifugal fans, the key to suffer is the wear of dust particles. This requires attention to the hazards of the surrounding environment when actually operating machinery and equipment, and choose a clean and dust-free natural environment as much as possible. If the smoke and dust are too large, it will easily cause the anti-corrosion centrifugal fan to be worn and cause harm to the aftermath.