The anti-corrosion fan manufacturer's fan is a kind of equipment that can convert mechanical energy into high-pressure wind energy. Therefore, performance advantages are widely used in major industries. However, due to long-term work and wear of the fan, its bearings may fail. So, what are the methods for anti-corrosion fan manufacturers to solve the vibration of the fan's bearings?
1. The dust in the non-working area causes the vibration of the fan of the anti-corrosion fan manufacturer, which is mainly manifested by the sudden increase of the vibration of the centrifugal fan during operation. This is because when the gas enters the impeller, there is a certain angle with the working surface of the rotating blade. According to the principle of fluid mechanics, the gas will produce a vortex on the non-working surface of the blade. Due to the vortex, the ash particles in the gas will slowly deposit on Non-working surface. In this case, the technicians of the anti-corrosion fan manufacturer only need to remove the dust on the blades, and the impeller will be balanced again, thereby reducing the vibration of the fan of the anti-corrosion fan manufacturer.
2. There is another treatment method for anti-corrosion fan manufacturers, which is to install a row of nozzles at the mouthpiece of the casing and adjust the nozzles to different angles. The nozzle is connected with the ash flushing water pump, and the ash flushing water is used as the motive medium for flushing the ash. After reducing the load, the unilateral fan is stopped, and the valve is quickly opened at the moment of stopping the fan. The inertia of the impeller is used to spray the non-working surface of the blade. Open the valve installed at the bottom of the cabinet to drain the flushing water.